Skip to content

Rental walkthrough checklist in Pakistan: 20 minutes

By Sakunat6 November 2026 6 min readAI-assisted
Tenant checking a tap and wall in an empty rented flat with a phone and notebook

You have the keys, the landlord is waiting downstairs, and the advance is already in his pocket. This is the moment most tenants in Karachi, Lahore and Islamabad rush through, and the one that decides whether you get your security deposit back a year later. A rental walkthrough checklist and twenty unhurried minutes inside the empty flat, with your phone and a notebook, will do more for you than any clause in the agreement.

Do it before you sign, and before the furniture

If you can, walk through the property before signing the agreement. If the landlord insists on signing first, add one line to the agreement: "Condition of the property is as per the attached photographs and checklist dated ___." That line turns your walkthrough from a private note into shared evidence.

Go in daylight. Evening hides stains, hairline cracks and damp patches. Switch on every light, open every tap and tell the landlord you will be quick. A reasonable landlord will not mind.

Start with water, because water is where the arguments are

Couple receiving the keys to their new home
Couple receiving the keys to their new home

Open every tap fully, then flush every toilet. You are checking three things: pressure, drainage and leaks under the sink.

  • Pressure: if the tap only trickles on the ground floor, it will be worse upstairs. Ask whether there is a tank and a motor, and who pays for the pump's electricity.
  • Drainage: fill the basin, then pull the plug. Slow draining means a blocked pipe that will be blamed on you in three months.
  • Under the sink and behind the toilet: put your hand there. A damp hand is a leak.
  • Geyser: ask to see it run. In a Lahore or Rawalpindi winter, a dead geyser is not a small matter. Check whether it is gas, electric or hybrid, and photograph the label.

Note which bathroom has an exhaust fan and whether it actually spins. Bathrooms without ventilation are the usual source of black mould by February.

Walls and ceilings: look up, look low

Most people look at eye level. Damp lives at the corners of ceilings and near the floor.

Stand in each room and look at the top corners. Yellowish rings or peeling paint usually mean seepage from the flat or roof above. Then crouch and check the lower 30 cm of external walls. Bubbling paint or a powdery white salt line means rising damp. If you want to know who pays when it shows up, the answer often depends on whether you recorded it before moving in, which is why this step matters.

Photograph every stain with a coin or a tape beside it for scale. Put the date in the photo name. Send the set to the landlord on WhatsApp the same day, so that there is a time-stamped record on both phones.

Electricity and gas: test the plugs, not just the lights

Bring a phone charger. Plug it into one socket in each room. Many rental flats have a few sockets that are dead or loose, and you do not want to find that out when the AC is installed.

Then look at the board:

  1. Is there a main breaker, and does it look new or scorched?
  2. Is the wiring for the AC points separate and thick, or has someone daisy-chained it?
  3. Ask how many amps the meter is rated for. A flat in DHA or Gulshan-e-Iqbal with two ACs, a geyser and a washing machine can strain a small connection.
  4. Read the meter and photograph it. Write down the reading in the agreement.

For gas, check that the stove burners light and that the pipe is not cracked or brittle. If the kitchen has no gas at all, ask whether the landlord expects you to use LPG cylinders, and where they can be stored safely. Do not accept a flat where the cylinder sits next to the geyser.

Doors, windows and locks

Open and close every door and window. Doors that stick in October will stick worse in monsoon humidity. Check that:

  • Every window latch works and the glass is intact.
  • Mosquito mesh is present where the building needs it, especially on ground floors near drains.
  • The main door has a working lock. Ask how many sets of keys exist, and who has the spares.

I always tell tenants to change or re-key the main lock at their own expense if the landlord agrees. It costs a few thousand rupees and removes a whole category of worry. Get the landlord's agreement in writing, and agree who keeps the old lock.

Fixtures and fittings: a quick inventory

If the flat comes with fans, lights, a kitchen cabinet or an AC, count them. Write down the number, the condition and any visible damage. Typical small items that get disputed later: curtain rods, tube-light fittings, bathroom mirrors, cabinet shutters and tap handles.

Take a short video, one minute per room, speaking out loud: "Master bedroom, window latch loose, scratch on the left wall." Narration is awkward but very persuasive if there is ever a disagreement.

Fix the list, then fix the paper

At the end of the walkthrough you will have a list of defects. Separate them into three groups:

  • Landlord must fix before move-in: leaks, dead sockets, broken locks, non-working geyser.
  • Landlord will fix within a set number of days: minor paint work, loose fittings.
  • Accepted as-is, recorded in the agreement: old scratches, faded paint, minor stains.

Put the list into the tenancy agreement or an attached sheet, signed by both sides. For a refresher on what the deposit clause should say and what papers help you recover it, read our guide to getting a rental deposit back, then check current listings in properties for rent so you know what comparable flats are actually asking.

A budget walkthrough kit

You do not need special tools. Here are three levels, depending on how much you want to spend.

Zero rupees: your phone camera, a notebook and a coin for scale. Narrate the video. Send photos to the landlord the same day.

Around PKR 1,000 to 3,000: add a phone charger as a socket tester, a small torch for dark corners and a cheap tape measure for checking where the sofa and bed will fit.

Around PKR 5,000 to 8,000: add a plug-in socket tester and a basic damp meter if you are renting a ground-floor or older flat. Prices vary by shop, so treat these as ballpark ranges.

After move-in: the first week

Use your first week to catch things you missed. Run the washing machine, the geyser and the AC together at least once. Check the water pressure at different times of day. Note when the water arrives if the area has scheduled supply. Send any new defects to the landlord in writing within seven days, with photos, and say plainly that you noticed them after moving in.

Keep your move-in folder somewhere safe: the walkthrough photos, the signed list, the meter reading and the agreement. When your lease ends, repeat the walkthrough with the same list and compare. That is the whole deposit conversation, settled with evidence rather than memory.

Before your next viewing

Print or save a one-page checklist from this article and take it to every viewing, not only the one you finally sign. By your third flat you will see patterns, and you will be able to tell a well-kept building from one where the landlord only paints before new tenants arrive. If you are also planning furniture and move-in logistics, use the rent vs buy calculator to check how long you realistically plan to stay, since that decides how much effort and money a flat deserves.

#renting#tenant tips#security deposit#move-in#checklist

Frequently asked questions

When should I inspect a rental property in Pakistan?

Inspect before you sign the agreement and before any furniture arrives, in daylight so stains, cracks and damp show up. If the landlord insists on signing first, add a line to the agreement that the property's condition is as per attached photographs and a signed checklist.

What should I photograph before moving into a rented flat?

Photograph every room, ceiling corners, lower walls, taps, under-sink areas, sockets, locks, the geyser label and the electricity meter reading. Place a coin or tape beside defects for scale, name files with the date, and send the set to the landlord on WhatsApp the same day.

Who pays for damp in a rented flat?

It often depends on the cause and what the agreement says. Seepage from the roof or a pipe is usually a structural matter for the landlord, but a tenant who did not record existing damp can struggle to prove it was there. A dated walkthrough record is your strongest evidence.